Aller au contenu
Premiers pas

Meta Portal family

Ce contenu n’est pas encore disponible dans votre langue.

Meta (formerly Facebook) sold the Portal as a video-calling smart display from 2018 until it stopped selling consumer models in 2022 (MobileSyrup, June 2022). Every Portal runs Android underneath Meta’s own interface, and Meta’s developer documentation describes an ADB Enabled switch under Settings › Debug on every model (Meta, Portal setup for Android apps). That switch is what lets Panel Assistant install its panel app, and it makes the Portal one of the very few cheap, widely available smart displays that can become a Home Assistant panel without root.

That makes it an attractive second-hand buy: a well-made 10 in screen with a camera, microphones, a speaker and a privacy slider, often for very little money. It also comes with conditions that a purpose-built wall panel does not have, chiefly a Meta account that has to stay signed in and a debugging connection that does not survive a restart. Read the 10” (2nd gen) page before you buy.

Facebook Portal, Meta Portal, Portal (2nd gen), Portal 10”, Portal Mini, Portal+, Portal Plus, Portal Go, model WD50JM (the 10” 2nd gen), device codenames omni and aloha, Meta’s software package prefix com.facebook.aloha.

Model Released Screen Android Device codename Status with Panel Assistant
Portal (2nd gen) 2019 10.1 in, 1280×800, landscape 10 omni (measured) Preliminary: one unit tested, with its own hardware profile
Portal Mini 2019 8 in, 1280×800 10 omni (one owner report) Family profile; untested
Portal+ (2nd gen) 2021 14 in, 2160×1440 10 not yet reported Untested; the family profile applies only if it reports omni or aloha
Portal Go 2021 10.1 in, 1280×800, battery 10 not yet reported Untested; the family profile applies only if it reports omni or aloha
Portal (1st gen) 2018 10.1 in, 1280×800 9 aloha (owner reports) Family profile; untested. An older platform with fewer sensors: reported to have ambient light but no motion sensor
Portal+ (1st gen) 2018 15.6 in, 1920×1080, rotating 9 aloha (owner reports) Family profile; untested
Portal TV 2019 none; plugs into a television 9 ripley (owner reports) Not supported: it has no screen or touch input of its own

Android versions follow Meta’s developer documentation, which lists the 2nd-gen family, Mini and Go on Android 10 and the 1st-gen models on Android 9. Both are above Panel Assistant’s minimum of Android 8.0.

The 10” (2nd gen) carries model number WD50JM on its label. That is the number to look for in a second-hand listing, because sellers often list every generation simply as “Portal”, and the 1st gen is a different, older platform.

Once the panel app is installed, it identifies the Portal from what Android reports about the device, not from the name Meta prints on the box:

  • A Portal reporting model Portal and device codename omni is treated as the 10” (2nd gen) and gets its own profile, with the camera, microphones and light sensor switched on as measured.
  • Any other Portal reporting omni (the Android 10 platform, which the Mini is reported to share) or aloha (the Android 9 platform of the 1st-gen Portal and Portal+) gets the Meta Portal family profile. That profile keeps the panel’s real screen-off and Meta’s launcher handling, but leaves the camera and microphone to the panel’s own checks rather than assuming them, and claims no light sensor or screen density, because none of that has been measured on those models.
  • A Portal reporting anything else, including the Portal TV’s ripley, runs on the Generic profile.

The panel app’s diagnostics show which profile was chosen and why. If you own a Portal Mini, Portal+ or Portal Go, the device codename it reports is the single most useful thing you can send in: it decides whether the family profile matches, and one report would move that model up the panel list.

These points come from Meta’s documentation or are properties of Meta’s shared software. They were confirmed on the 10” (2nd gen) and are expected, not proven, on the other models.

  • ADB is a Meta setting, not Android’s developer options. It is under Settings › Debug › ADB Enabled, and Meta’s documentation says to enter your PIN if prompted. On the tested unit the PIN was the one set for the Meta account during setup.
  • Setup needs a Meta sign-in before Settings can be reached. Meta offers Facebook and WhatsApp sign-in; only Facebook worked for us. Keep that account signed in for as long as you use the Portal as a panel; the 10” (2nd gen) page explains why.
  • No root. Retail Portals ship locked production builds with no su, and no bootloader unlock is known. Panel Assistant does not need root on a Portal, but root-dependent self-update and screenshot-based remote control are unavailable. The tested Portal runs Android 10, below the Android 11 requirement for Accessibility screenshots without root.
  • Meta’s own WebView. The tested Portal renders web content with Meta’s own build of the Chromium WebView (131), which is current enough for Home Assistant dashboards with no update. Meta’s software keeps its own packages up to date in the background.
  • Meta is winding Portal down. Meta stopped selling Portals in 2022 and has withdrawn features since. Expect more of Meta’s own services, and possibly sign-in methods, to stop working over time. The panel app does not depend on any of them, but the Meta account and the ADB switch it gates are outside anyone’s control but Meta’s.

Commentaires

Les commentaires sont conservés dans la discussion de cette page sur GitHub. Les charger connecte donc votre navigateur à GitHub. Ce navigateur mémorise votre choix et charge les commentaires des autres pages lorsque vous faites défiler la page jusqu’à eux.

Nous Home Assistant et tout ce que fait l’Open Home Foundation.

Dernière mise à jour :

Build 212 · 61ef6de